Paveikslėlyje parodyta:
Bathtub 1600 x 700 mm. For images with frame, see IMAGES.

Description
The bathtub is made of enameled steel plate. Supplied without support, but with waste pipe, installed waste fitting and chromed pop-up valve. The bathtub is designed for installation  with a full, half or design front frame. The frame is made of powder-coated aluminum and has feet with 25 mm of adjustment. The full and half front frame slides sideways and inwards in relation to the bathtub to provide space for pipe routing on walls. The lower section of the full front slides up to increase accessibility when cleaning. The full front frame is supplied with a visible front and end as standard. In cases where a bathtub with a full or half front frame is installed with two long or short sides visible, supplement with an additional front or end. Order front and end pieces for the design front according to the number of sides that will be visible. In cases where a bathtub with a design front is installed with two long or short sides visible, additional fittings must be ordered with the extra front or end.


Approval & standards
The product conforms to AMA recommendations as well as SS-EN 232.

Logistika
The bathtubs are protected during transport on pallets with up to 13 tubs per pallet. For weights, see table in catalog. The pallet weighs 16 kg. Frame, fronts and ends are supplied packaged in boxes with 26 frames per pallet.

Components Connection
Water volume 190 liters.

Complementary information
The bathtub can be ordered with glazeplus, an anti-slip treated bottom and/or support handle. For part numbers, see our printed material.

Supplementary products
Bathtub 1607 can be supplied with design front frame 5016 instead of full or half front frames - see page xxx.

Montavimas
The front frame for the full or half front frame is supplied with the ends ready fitted. The front and concealed profile are then assembled into a frame. The frame is adjusted horizontally using the adjustable feet. The bathtub, which is equipped with a damping/friction material under the corners, is placed in the frame. The plastic waste pipe is cut and connected to the floor drain. Installation instructions are included. Note for design fronts. Safety glass is highly resistant to knocks and bending. However, the material does not tolerate blows to the corners or edges. These are protected after installation but not during fitting. Always use a soft underlay when the glass is placed on the floor. Glass with damaged edges should not be installed and should be replaced immediately.